Ez way tower manual

It actually is an EZ Way tower, model HD They are a telescoping tower, and when extended fully are about 36 feet tall. They also had a "Wonder Pole" option, which allowed the tower to be tilted down, using the pole as a cantilever point. The original setup had the hinge point at 6 feet up the lower tower section. desired height, into each E-Z Tower bracket leg-socket. Ensure that each post is seated completely into each leg-socket mark the posts through the leg holes on each bracket. Drill ¼” pilot holes into posts secure to brackets with 3/8”x/2” lag screws flat washers. Step 4: Using 1x or 2x dimensional lumber.  · New Life for old EZ Way Tilt-over Crank-Up Tower. Several years ago I acquired an unidentified tilt-over crank-up tower. Manual winches, it appeared to be about 60 feet tall. The deal was take it down and it is yours. So it has sat behind my shop for about 10 years. Recently, I saw a picture on the internet of an identical tower, and it was.

Designed -to accommodate E-Z WAY crank-up, tilt-over towers, Equipped to Customer's specifications: outriggers, stop and turn signals, elec- tric brakesr spare tire and wheel. Finished with primer and color painted 'o customer's choice, Available With motor winches, guy hard- ware and other accessories. Trailer Mounted Mounted Engineering and. Never operate the mower’s engine while using the MoJack EZ. Do not exceed the lifting capacity of lbs. If the MoJack EZ Tower is leaning while lifting or lowering the mower, this indicates an overload condition. Remove the mower immediately. Tower must be locked in place with the Tower Locking Pin before using the MoJack EZ. It was already curved looking like it was getting ready to sag over. I was % DISAPPOINTED with my EZ Way tower. It was a huge waste of time and much money. In those days, there was little way for hams to spread the word about defective products since there was no internet or social media. Stay clear of EZ Way towers. They are trouble.

ich E-Z Way tower is load rated for 50 MPH winds. Use the chart below to select the tower for your antenna ad. All towers are designed for mph winds. The EZ-ZONE® RM High Density module is manufactured by ISO User's Guide, part number: the way that the hardware can be connected. Method of return shipment. • Your P.O. number The EZ-ZONE PM Limit Controller User's Manual #, EC Dream Tower, 46, Yangpyeongdong-3ga.